Wacker Neuson KRAMER 5055e User Manual

BA 357-00 * 3.0 * 35700_07_Wartung.fm 7-39
Maintenance 7
Removing the battery charger
As soon as charging is finished and the machine is to be used again, the
battery charger must be separated from the power source.
1. If the battery cover plate was closed, carefully open
the battery cover plate.
2. Briefly press the pause button D on the battery charger.
➥ The charging is interrupted for a minute.
3. Disconnect the mains cable connector from the power source.
4. Wind up the mains cable and stow it securely on the battery charger.
5. Close and lock cover A of the battery charger.
Information
If the cover of the battery charger is not closed, the start-up protection is
not disabled and the vehicle can be put into operation.
6. Close the battery cover plate.
The machine can be used again when the battery charger is disconnected
from the power source.
Fig. 221
D
Fig. 222
A

Wacker Neuson KRAMER 5055e Specifications

General

Brand	Wacker Neuson
Model	KRAMER 5055e
Category	Front End Loaders
Language	English