BA 357-00 * 3.0 * 35700_03_Einleitung.fm 3-33
Introduction 3
Information labels
Accident hazard due to damaged or missing information labels!
Can cause serious injury or death.
► Immediately replace damaged or missing information
labels by new ones.
► This particularly applies to information labels referring
to hazards (e.g. load diagrams)!
Slinging points and tie-down points
The label identifies the slinging points A and the tie-down points B
on the machine and the battery.
Slinging points A are used for loading with a crane.
Tie-down points B are used for securing the transport.
The symbols for the slinging points A and tie-down points B may
also appear separately on their own labels.
Located on left and right of machine frame above
the front axle attachment and at the rear and on the battery.
Design-specific max. machine speed!
The label indicated the design-specific, permitted
maximum machine speed.
Located at the rear of the machine and left / right on the battery holder.
The maximum speed of the machine is approx. 17 km/h (10.56 mph).
In this regard, the machine falls with the category of vehicles with a
maximum permitted max. speed in Germany of 20 km/h (12.44 mph).
This is the fact that is documented by the label and not the maximum
achievable speed of the machine.
To Next Page
Loading...
Need help?
General
