4-8 BA 357-00 * 3.0 * 35700_04_Inbetriebnahme_01.fm
4 Putting into operation
General instructions
Electronic components such as power electronics and the StVZO module
are located under the operator seat. The operator seat can be folded to
make these components accessible for maintenance and repair work.
• Before folding up the operator seat, the safety instructions for the
operator seat must be observed.
– see "Safety instructions" on page 4-7.
The machine is equipped with an operator presence switch
to protect the operator. In this case:
• The machine can only be switched on if the operator has taken his
place in the operator seat.
• If the operator seat is relinquished for more than 3 seconds during
machine travel, the machine is braked until it comes
to a standstill and the parking brake engaged once in standstill.
• A warning signal sounds if the operator seat is relinquished for more
than 3 seconds without engaging the parking.
➥ The buzzer stops if the operator seat is occupied or the parking
brake applied.
Always adjust the operator seat to match the individual needs of the
operator, e.g. body size and body posture. This prevents muscle tensions
and fatigue during work.
Adjust the operator seat ensuring that the control levers and pedals are
within easy reach with your back against the backrest.