4-22 BA 357-00 * 3.0 * 35700_04_Inbetriebnahme_01.fm
4 Putting into operation
Motor isolating switch
The entire traction and works electronics can be disconnected or
connected with the supply voltage using the motor isolating switch.
The parking brake is applied at the same time when the traction and works
electronics is disconnected from the supply voltage.
Accident hazard when turning off the motor isolating switch during
machine travel.
This can result in injuries since the machine sharply brakes when the
parking brake is applied.
► Only switch off the motor isolating switch when
the machine is in standstill.
The motor isolating switch A is located in the cab to the left next to the
operator seat.
Switch off motor isolating switch
1. Push down button A.
➥ The entire traction and works electronics are out of operation.
➥ The parking brake is applied.
Switch on motor isolating switch
1. Pull button A upwards.
➥ If the battery connector is connected, then the entire traction and
working electronics are in operation.
Fire extinguisher (option)
The fire extinguisher is not supplied with the machine.
• It is installed on the right on the seat pan, below the control lever base.
• Operate the fire extinguisher according to the instructions
printed on the fire extinguisher.
In order to ensure the full serviceability of the fire extinguisher:
► Have the fire extinguisher checked at regular intervals and refilled, see
inspection tag.
► Only remove the fire extinguisher from the cab in an emergency.
► After the fire extinguisher has been used: have it filled by an authorized
service center or replace it with a new one.
To Next Page
Loading...
Need help?
General
