WAGNER PEM-X1 - Page 4

Operating manual Manual powder spray gun PEM-X1
Table of Contents
4 Order number 2326020 | Edition 10/2022
6.6 Grounding 25
6.6.1 Grounding the powder coating system 25
6.7 Safety Checks 26
7 Operation 27
7.1 Training the Operating Personnel 27
7.2 Tasks 27
7.3 Switching on the Manual Powder Spray Gun 27
7.4 Optimizing the Powder Cloud for Coating 27
7.4.1 Recommended Settings for Total Air Volume 27
7.5 Adjustment of Powder Quantity 28
7.6 Double Click Program (High Dynamic Remote) 28
7.7 Switching off the Manual Gun 29
7.7.1 Pressure Relief / Work Interruption 29
7.8 Reproducible setting of the nozzle position 30
8 Cleaning and Maintenance 31
8.1 Cleaning 31
8.1.1 Cleaning Personnel 31
8.1.2 Cleaning Procedures 31
8.2 Maintenance 31
8.2.1 Maintenance Personnel 31
8.2.2 Maintenance Instructions 31
8.2.3 Safety Checks 32
8.2.4 Maintenance Procedures 32
8.3 Exchanging the Manual Gun 32
8.4 Changing the Flat Jet Nozzle 34
8.4.1 Removing the Flat Jet Nozzle 34
8.4.2 Fitting the Flat Jet Nozzle 35
8.5 Changing the Round Jet Nozzle 36
8.5.1 Removing the Round Jet Nozzle 36
8.5.2 Fitting the Round Jet Nozzle 37
8.6 Replacing the Protective Wedge 37
8.6.1 Removing the Protective Wedge 37
8.6.2 Installing the Protective Wedge 38
8.7 Changing Nozzle Types 39
8.8 Assembly of the CoronaStar 41
8.9 Replacing the Suspension Hook 42
9 Troubleshooting and Rectification 43
10 Inspections in Accordance with DIN EN 50050-2: 2013 44
10.1 Abbreviations 44
10.2 Overview Table 45
11 Disassembly and Disposal 46
11.1 Disassembly 46
11.2 Disposal 46
12 Accessories 47
12.1 Nozzle systems 47
12.1.1 Flat Jet Nozzles System X1 47
12.1.2 X1 F Flat Jet Nozzles System 47
12.1.3 X1 R Round Jet Nozzles System 48
12.1.4 Nozzle extension 48
12.2 Hose take-up 49