217
W&T Appendix
Subject to error and alteration
• Com-Server Reset and Port Reset
(see section on Reset Com-Server-Port and Reset the Com-
Servers)
The TCP ports 8888, 9084/9184/9284 allow resetting of
fixed modes of a port and for fully resetting the Com-Ser-
ver. All the ports are not configurable and are protected by
the system password.
• Controlport
(see section on The Control Port)
The TCP control ports (factory defaults 9094/9194/9294
for ports A/B/C) allow the COM port redirector as well as a
customer’s own applications to configure the serial trans-
mission parameters and control lines of the individual
serial ports on a Com-Server. All ports are protected by the
system password.
To Next Page
Loading...
