24
W&T Assigning the IP address
by commas and follows the IP address. Entering as shown in
the following example will assign IP address 172.17.231.99,
subnet mask 255.255.255.0 and gateway 172.17.231.52 to
the Com-Server
Exampel: Assigning the IP address:
IP no.+<ENTER>: <- Com-Server
172.17.231.99 -> Com-Server
Example: Assigning IP address, Subnet mask and gateway
IP no.+<ENTER>: <- Com-Server
172.17.231.99, 255.255.255.0,172.17.231.1 -> Com-Server
Option: Activating Web Based Management (WBM)
To further configure the Com-Server you can use either Telnet
protocol or an Internet browser, although only Telnet is an
option in the Com-Server as shipped from the factory. You
can activate Web Based Management as part of the serial IP
assignment. To do this, enter +w[Portno.] directly after the
IP address or address string. Here Portno. is the desired TCP
port in decimal format.
Exampel 1: Assigning the IP adress and WBM on Port 80.
xxx... -> Com-Server
IP no.+<ENTER>: <- Com-Server
172.17.231.99+w80 -> Com-Server
172.17.231.99-1 <- Com-Server
Exampel 2: Assigning IP address, subnet mask, gateway and
activating WBM on port 8800.
xxx... -> Com-Server
IP no.+<ENTER>: <- Com-Server
172.17.231.99,255.255.0.0,172.17.231.1+w8800 -> Com-Server
172.17.231.99,255.255.0.0,172.17.231.1+w8800 <- Com-Server
To Next Page
Loading...
