W&T Com-Server++ - Page 60

60
W&T The basis configuration of the Com-Server
n System Port List
From the respective submenus you can configure and
disable the TCP and UDP port numbers under which the
following configuration and control accesses for the Com-
Server are reached. Entries are made in decimal. The value
0 disables the service.
The TCP/UDP ports with access to the serial port on the
Com-Server can be configured from the submenu Setup
Port x r TCP/IP Mode r Port List konfiguriert werden.
• WBM Port (Default = TCP/0)
Chapter Configuration via Browser
• Telnet Configuration Port (Default = TCP/1111)
Chapter Configuration via Telnet
• SNMP (Default = UDP/161)
Chapter SNMP management
• Device Reset Port (Default = TCP/8888)
Chapter Reset of the Com-Server
• Init Flash Update Port (Default = TCP/8002)
Chapter Firmware update of the Com-Server
• Read Config Port (Default = TCP/8003)
Chapter Up-/Download configuration data
• Write Config Port (Default = TCP/8004)
Chapter Up-/Download configuration data
• Info Port (Default = UDP/8513)
Chapter Inventory via UDP
1
Changes to the factory default port numbers as
well as disabling services should be done with cau-
tion, since they can result in malfunction of configuration
and management tools such as WuTility. If for example the
telnet configuration and WBM are disabled, you can no lon-
ger configure the Com-Server. Restore the factory default
values by performing a hardware reset of the Com-Server.