78
W&T Configuration of the serial port
Telnet Port/TCP
(Default = 6000/Port A, 6100/Port B, 6200/Port C)
The telnet port allows access to the serially connected device
with a standard telnet client. The port is always required for
Telnet Server mode.
For detailed information see chapter:
Telnet Server
FTP Port/TCP
(Default = 7000/Port A, 7100/Port B, 7200/Port C)
The FTP port enables access to the serially connected device
with a standard FTP client. The port is always required for FTP
Server mode.
For detailed information see chapter:
FTP Server
Reset Port Status
(Default = 9084/Port A, 9184/Port B, 9284/Port C)
For special applications this port offers the ability to carry out
a forced reset of the Com-Server port: the parameters for the
current connection are deleted.
For detailed information see chapter:
Reset Com-Server Port
To Next Page
Loading...
