W&T Com-Server++ - Page 98

98
W&T Mode TCP client
Closing the TCP connection
SETUP Port x
TCP/IP Mode
...
TCP Client
...
Special Options
Inactivity Timeout
Disconnect Char
Connection Timeout
To close the connection the following methods from the Sub-
menu ...TCP Client r Special Options are available. If connec-
tion control is configured using the handshake inputs CTS or
DSR, the connection is also closed when this line drops.
n
Inactivity Timeout
Default: 30
Here you can specify the value for a timer. When the
specified time expires, the Com-Server port closes the
connection. The timer is reset if there is an active network
connection when data are being exchanged. If no data are
set within the specified time, the Com-Server port closes
the connection to the TCP server. InactivityTimeout = 0
deactivates the connection closing after a timeout.
1 tick: 1 second
Format: decimal
n
Disconnect Char
Default: 0
If the Com-Server receives the character defined here at
the serial port, the connection to the TCP server is closed.
The character itself is not sent to the TCP server. Default
value is 0 (=deactivated).
Format: decimal