Waters 2414 - Page 10

June 11, 2015, 715004754 Rev. A
Page x
1.3.6 Optics............................................................................................ 30
1.3.7 Electronics...................................................................................... 30
1.3.8 Temperature control......................................................................... 33
1.3.9 Startup diagnostics tests .................................................................. 34
1.3.10 Bootloader program ....................................................................... 34
2 Installing the Detector ............................................................. 35
2.1 Before you begin ...................................................................................... 35
2.2 Unpacking and inspecting .......................................................................... 35
2.2.1 Unpacking...................................................................................... 36
2.2.2 Inspecting...................................................................................... 36
2.3 Selecting a laboratory site ......................................................................... 36
2.4 Stacking system modules .......................................................................... 37
2.5 Connecting to the electricity source ............................................................. 37
2.6 Connecting tubing and attachments ............................................................ 39
2.6.1 Connect a column or second detector................................................. 39
2.6.2 Connect to waste............................................................................. 40
2.6.3 Connect to a drip tray ...................................................................... 40
2.6.4 Connect the valve pack drip tray........................................................ 41
3 Connecting Signal Cables ......................................................... 43
3.1 Component connection overview ................................................................. 43
3.1.1 Supported IEEE-488 and Ethernet configurations ................................. 44
3.2 Ethernet signal cable connections ............................................................... 44
3.2.1 Connecting to a Waters data control system via the Ethernet port.......... 45
3.3 IEEE-488 signal cable connections .............................................................. 45
3.3.1 Connecting to a Waters data control system via the IEEE-488 bus interface..
46
3.3.2 Setting the IEEE-488 address............................................................ 46
3.3.3 Connecting to a manual injector ........................................................ 47
3.4 Analog-out/event-in (I/O) connections ......................................................... 47
3.4.1 Connecting to a standalone Alliance e2695 separations module.............. 48
3.4.2 Connecting to a data control system using analog signals ..................... 51
3.4.3 Connecting injection trigger signals.................................................... 52
3.4.4 Polarity connections......................................................................... 55