16 Preparing the Separations Module for Operation
4. Enter a time period (in minutes) after which you want the Separations Module to
shut down (or press
Clear
to disable the Auto Shutdown function).
5. Press
OK.
The Separations Module shuts down when there has been no activity
for the specified period.
6. Press
Exit
to return to the Main screen.
Note:
If you want to use Auto Shutdown to turn off the lamp of a 2487 or 486 detector,
program a Lamp Off event and specify a time of INIT in the I/O Events Timed Table screen
(see Section 6.2.5, Setting I/O Parameter Values in the Waters 2690 Separations Module
Operator’s Guide).
To Next Page
Loading...
