Performing a Direct Control Run 33
Syr Indicates the current position of the syringe. Valid positions are:
• Home – Default position
• Empty – Highest position (to purge the syringe)
• Full – Lowest position (to draw in sample)
Vial Indicates the number of the vial that is currently under the
injector.
Ndl Wash Indicates whether the needle-wash pump is on.
Sample Indicates the current pressure in the sample loop.
Column Temp Indicates the desired and current temperature of the column (if
the column heater is installed).
Injector Indicates the current position of the injector. Valid positions are:
• Stream – In the high pressure stream
• Seal – In the lower seal position
• Wet – In the needle wash position
• Vial – In the sample vial
486 (1) and (2)
•
λ
• Lamp
•AUFS
Indicates the current status of the following parameters for the
486 detector(s) (if installed).
• Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
2487 (1) and (2)
•
λ
• Lamp
•AUFS
Indicates the current status of the following parameters for the
2487 detector(s) (if installed):
• Wavelength
• Lamp On or Off
• Absorbance Units Full-Scale
Table 3-1 Status Screen Parameters
(Continued)
Parameter Description
To Next Page
Loading...
