November 16, 2016, 715004521 Rev. C
Page vi
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Electrical power safety notice
Do not position the instrument so that it is difficult to disconnect the power cord.
Equipment misuse notice
If equipment is used in a manner not specified by its manufacturer, protections against personal
injury inherent in the equipment’s design can be rendered ineffective.
Safety advisories
Consult Appendix A for a comprehensive list of warning advisories and notices.
Operating this system
When operating this system, follow standard quality-control (QC) procedures and the guidelines
presented in this section.
Applicable symbols
Symbol Definition
Manufacturer
Date of manufacture
Authorized representative of the European Community
Confirms that a manufactured product complies with all applicable
European Community directives
or
Australia EMC compliant
Confirms that a manufactured product complies with all applicable
United States and Canadian safety requirements
Consult instructions for use
To Next Page
Loading...
