Watlow CLS200 - Page 180

180
Index
A
AC LINE FREQ
default value 67
description 73
location 66
AC Line Frequency 73
A control status symbol 52
agency compliance
controller 162
ALARM ACK key
acknowledging alarms 55
description 50
does not work 145
ALARM DEADBAND
default value 90
description 92
location 66
ALARM DELAY
default value 90
description 93
location 66
using 59
Alarm High SP parameter 62
Alarm Low SP parameter 62
alarms
acknowledging 55
codes 140, 141
deadband 92
delaying 59, 93
deviation 140
digital output polarity 73
disabling control on alarm outputs 85
displays 53
failed sensor 59, 141
global 62, 63, 174
global alarm output 14, 38, 41, 42, 43, 50,
53, 60, 61, 73, 94, 130, 169
high deviation alarm settings 91
high process alarm settings 90
hysteresis 61, 62
loop delay 59
low deviation alarm settings 91, 92
low process alarm settings 92
messages 141, 142
process 140
resetting 141
restoring control after sensor failure 83
reversed thermocouple 77
SCRs 38
sensor fail percent output power 88
setting up 61
setup parameters 89
solid state relays 38
startup delay 59, 70
system 55, 142
T/C BREAK, switching to manual mode 88
tolerance 119, 129
troubleshooting 140, 141
wiring 38
ambient temperature
H/W AMBIENT FAILURE message 144
operating range 20, 162
AMBIENT WARNING 144
analog output 135
ASSIGN R/S PROFILE 127
AUTO 52
automatic control, selecting 56
autotuning 57
B
BACK key 50
bar graph display 51, 52
control status symbols 52
navigating in 52
ramp/soak symbols 126
symbols 51, 52, 54
when running ramp/soak profile 126
battery 17, 152
BATTERY DEAD 142, 143, 152
baud rate 72
block check character 72
boost output 62
bridge circuits 34