WEG CFW500 - Page 3

Summary of Reviews
English
The information below describes the reviews made in this manual.
Version Review Description
- R00 First edition
- R01 General review and inclusion of the new models
- R02 Modification in Table B.6 on page 165 and in the printing of the filter switch
- R03 General review and inclusion of frame size D
- R04 General review
- R05 General review and inclusion of frame size C 500 / 600 V
- R06 General review and inclusion of frame size E
- R07 General review
- R08 General review, inclusion of frame size F and functional safety
NOTE!
The inverters CFW500 have the default parameters set as described below:
 60 Hz for models without internal filter.
 50 HZ for models with internal filter (check the smart code
E.g.: CFW500A04P3S2NB20C2).
ATTENTION!
Check the frequency of the power supply.
In case the power supply frequency is different from the default frequency
(check P0403), it is necessary to set:
 P0204 = 5 for 60 Hz.
 P0204 = 6 for 50 Hz.
It is only necessary to set these parameters once.
Refer to the programming manual of the CFW500 for further details about the
setting of parameter P0204.