上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
8 / 61
and turn the handwheel knob by a certain degree to make the target
axis move in the target direction.
Stepping: Select 0.01, 0.05, 0.1, 0.5, 1, 5, or 10 (the unit is mm), or
enter a value in the blank field. Click and release an axis button to
make the target axis move in the target position by the set step.
Note: Please do not set the step to a value that's too large to avoid
damage due to misoperation, and do not click an axis button too
frequently in short time.
o Common function: Going to the fixed point
o Common ports: Spindle, Cool, Vacuum, Lube, etc. The common ports can
be modified in NcConfig.
Homing
o Tick Execute homing when software starts to make the axes go to the
mechanical origin upon software start.
o You can also check and clear the homing average values in this area.
1.3.3.8 Operation Button Bar
You can use the following functions with buttons in the operation button bar:
In Auto and Manual modes:
Loading and unloading of programs
Axis clearing
MDI, selective machining, going to the workpiece origin, and simulation
Using the handwheel to control machining movement
Starting, pausing, or stopping machining; resuming machining from the interrupted
point
In Homing mode:
Making the axes go to the mechanical origin
Starting, pausing, or stopping machining; resuming machining from the interrupted
point
To Next Page
Loading...
General