Wivis CPU-NXT3.2 - Tools Required

1-2
Chapter 1: Introduction and Features
Aug 2012
Tools Required The following tools are required to complete the procedures in this manual:
Figure 1-2 T8 Torx screwdriver (left), T10 Security Torx screwdriver (left), and tip-end of driver (center).
 ESD wrist strap
 #2 Phillips screwdriver (magnetized recommended)
 7/8-inch socket
 7/16-inch nut driver or ratchet
 3/16-inch nut driver (thin wall)
 3/16-inch Flathead screwdriver (magnetized recommended)
 1/4-inch Flathead screwdriver (magnetized recommended)
 Insulated needle-nose pliers
 File Compression Program (such as WinZip - If you do not have Winzip, it can be
downloaded for free) (for RAM Dump)
 USB CompactFlash® Card Reader (for RAM Dump)
 Desktop or Laptop PC (for RAM Dump)
 T8 Security Torx screwdriver (magnetized recommended), Figure 1-2 (A)
McMaster Carr p/n 83335A69 (Tamper-Resistant Torx Driver T8 Torx)
2-13/32-inch Blade Length
6-1/2-inch Overall Length
 T10 Security Torx screwdriver (magnetized recommended), Figure 1-2 (B)
McMaster Carr p/n 83335A61 (Tamper-Resistant Torx Driver T10 Torx)
3-inch Blade Length
7-1/2-inch Overall Length
A
B