To Next Page

To Previous Page

5 Self-Diagnosis Mode RJ-901C/RJ-900C　 Maintenance Manual

5-66

5.9.5 Pump Endurance Menu

This menu performs endurance running for the pump motor assembly.

In this menu, pump motor can be driven according to the value set. The available settings are shown below.

TIP

• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance

running until cancel input is given from the operation panel.

• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If

the number of cycles exceeds the maximum value, the counter is reset to 0.

Table 5-20 Set Items in Pump Motor Assembly Endurance Menu

Set item Contents Set value Remark

Running speed Set the running speed of

pump motor assembly.

Super High / High /

Normal

Number of endurance

running cycles

Set the number of endurance

running cycles

-1 to 10000

Previous menu

Next menu

Previous menuNext menu

Next menu

[Enter]

key

[Enter]

key

[Enter] key

[Enter] or [Cancel ] key

[Enter]

key

Endurance Count

Performing Endurance

Xerox 7142 Service Manual

Questions and Answers: