Xerox 7142 - Adjustment Procedures

To Next Page

To Previous Page

RJ-901C/RJ-900C Maintenance Manual 7 Adjustment

7-1

7 Adjustment

7.1 Introduction............................................................................................. 7- 3

7.2 Adjustment Item...................................................................................... 7- 3

7.3 Working with Dedicated Network Software.......................................... 7- 9

7.3.1 Parameter Backup......................................................................... 7-9

7.3.2 Jigs and Tools................................................................................ 7-9

7.3.3 Required Environment................................................................. 7-10

7.3.4 Receiving Parameters.................................................................. 7-13

7.3.5 Firmware Installation.................................................................... 7-14

7.3.6 Sending Parameters.................................................................... 7-18

7.4 PF Speed Reduction Belt Tension Adjustment.................................. 7- 20

7.4.1 Jigs and Tools.............................................................................. 7-20

7.4.2 Adjustment Procedure ................................................................. 7-20

7.5 PF Encoder Assembly Position Adjustment...................................... 7- 22

7.5.1 Jigs and Tools.............................................................................. 7-22

7.5.2 Adjustment Procedure ................................................................. 7-22

7.6 CR Belt Tension Adjustment ............................................................... 7- 24

7.7 Head Slant Adjustment (Horizontal).................................................... 7- 25

7.8 Head Slant Adjustment (Vertical) ........................................................ 7- 27

7.9 Cutter Holder Height Adjustment........................................................ 7- 28

7.9.1 Jigs and Tools.............................................................................. 7-28

7.9.2 Adjustment Procedure ................................................................. 7-28

Related product manuals