Xerox Color C75 Press - Page 297

012-296
Cause: The finisher malfunctioned.
Remedy: Perform the following:
Power off/on the machine, and if necessary, resend/restart your print job.
If the error persists, contact the Customer Support Center.
• Check for any obstructions in the paper path and clear them.
012-400
Cause: Staple Waste Container near full
Remedy: Follow the procedures to remove and replace the staple waste container in
the finisher.
012-949
Cause: Punch Waste Container is not attached
Remedy: Check that the punch waste container is installed in the finisher and inserted
correctly.
024-931
Cause: The Staple Waste Container is full or near full
Remedy: Remove the Staple Waste Container and install a new one.
024-932
Cause: The Staple Waste Container is not attached
Remedy: Check that the Staple Waste Container is installed in the finisher and inserted
correctly.
024-943
Cause: The booklet staple cartridge is empty or stapling error occurred.
Remedy: Perform the following:
• Check the staple cartridge and reset correctly.
• If necessary, replace with a new cartridge.
• Resume job.
024-957
Cause: Post-Process Inserter Tray (Tray 8/T1) is empty or out of paper
Remedy: Add paper to the paper tray.
024-974
Cause: When feeding paper from the Post-Process Inserter Tray, the designated paper
size and the actual size of paper in the tray differ.
Remedy: Reset/change the paper or cancel the job.
17-49Xerox
®
Color C75 Press
User Guide
Standard/Booklet Maker Finisher