9
Maintenance
Cleaning the machine
Read and adhere to the following information when cleaning the machine:
• Before you start to clean the machine, be sure to switch off the power and unplug
the machine. Cleaning the machine without switching off the power may cause an
electric shock.
• Do not use benzene, paint thinner, other volatile liquids, or spray insect repellent on
the machine as doing so may discolor, deform, or crack covers.
• Cleaning the machine with an excessive amount of water may cause the machine
to malfunction and/or damage documents during copying.
• Document feeder, cover, and glass information:
- The document cover is the flat, white surface on the underside of the DADF that
holds the document in place on the document glass.
- It is recommended that you clean all components of the document cover and
document glass at the same time. These components consist of the document
cover, the document (platen) glass, and the second-side scanning lens assembly.
- Cleaning the document cover and glass on a regular basis is important to providing
the best image quality possible on your printed or copy output. If the document
cover and document glass are dirty, spots may appear on copies and the machine
may not properly detect document sizes.
- Perform the cleaning procedure for the document cover and document glass if
you receive this message, The Scanner may be dirty; see User Guide or label
instructions on the Document Feeder to wipe the scanning glass.
- The document (or platen) glass consists of two parts: the document glass itself
and the glass strip. The document glass is the glass on which you place your
document in order to copy it. The glass strip is an approximately one-inch wide
strip of glass located to the left the document glass.
9-1Xerox
®
Color C75 Press
User Guide
To Next Page
Loading...
Need help?
General
