Xerox Color C75 Press User Manual

Trimmer feature
The Trimmer feature can be selected/accessed from your computer print driver, the
machine UI, or from the print server.
Note
The Trimmer feature is available only when your machine is connected to both a finisher
with a booklet maker and the SquareFold Trimmer Module.
Trimmer options
When using the Trimmer options, always consider the following:
• Booklets exiting/leaving the SquareFold Trimmer Module may contain trim
remnants/scraps from the previously trimmed booklet. This is due to static electricity
build-up and is normal. If booklets contain trim remnants/scraps, simply remove and
discard them.
• The Trimmer feature can be switched on or off based on user preference. When the
feature is switched on, you can adjust the trim setting in 0.1 mm/0.0039 in. increments
depending on your requirements for the finished booklet job.
Note
For the remainder of this section, the machine UI screen is shown. The individual print
server and print driver screens are not shown. The descriptions given for each of the
Trimmer options are applicable for network print jobs, and apply to any print server/print
driver connected to the machine.
Xerox
®
Color C75 Press18-8
User Guide
SquareFold Trimmer Module

Xerox Color C75 Press Specifications

General

Copy speed (black, normal quality, A4)	75 cpm
Maximum print size	A3 (297 x 420 mm)
Media types supported	64 – 300 g/m2
Standard input capacity	1900 sheets
Maximum resolution	2400 x 2400 DPI
Standard printer languages	PCL 5c, PCL 5e, PCL XL, PDF 1.7+, PostScript 3
Standard interfaces	USB 2.0
Networking features	TCP/IP, Novell, NDS, IPX/SPX, IPP AppleTalk, IPP, NetBEUI, DHCP
Internal memory	- MB
Maximum duty cycle	300000 pages per month
Power requirements	100-240 VAC, 50/60 Hz
Dimensions (WxDxH)	1714 x 777 x 1372 mm
Type	Digital copier