Printer Connection and Software Installation 132
•WPS-PIN
NOTE:
• WPS-PIN is a method to authenticate and register devices required for wireless configuration, by entering PIN
code to a printer and computer. This setting, performed through access point, is available only when the
access points of your wireless router supports WPS.
• Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless access point.
See the access point manual for the details.
1 On the operator panel, press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Network, and then press the button.
4 Select Wireless Setup, and then press the button.
5 Select WPS, and then press the button.
6 Select PIN Code, and then press the button.
7 Take a note of PIN code displayed on the operator panel.
8 Select Start Configuration, and then press the button.
9 If SSID selection screen appears, select the SSID, and then press the button.
10 Enter the PIN code of the printer at the web page of the wireless access point.
11 Wait a few minutes until the printer restarts to establish the wireless network.
12 Print a System Settings page from the operator panel.
See "Printing a System Settings Page" on page 182.
13 Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
To Next Page
Loading...
Need help?
General