Troubleshooting 380
Print Quality Problems
This section includes:
• "The Output Is Too Light" on page 381
• "Toner Smears or Print Comes Off/Stain on Back Side" on page 382
• "Random Spots/Blurred Images" on page 383
• "The Entire Output Is Blank" on page 384
• "Streaks Appear on the Output" on page 385
• "Mottle" on page 386
• "Ghosting" on page 387
• "Fog" on page 388
• "Bead-Carry-Out (BCO)" on page 389
• "Auger Mark" on page 390
• "Wrinkled/Stained Paper" on page 391
• "The Top Margin Is Incorrect" on page 392
• "Protrudent/Bumpy Paper" on page 393
NOTE:
• In this section, some procedures use the Printer Setting Utility or SimpleMonitor. Some procedures that use
the Printer Setting Utility can also be performed using the operator panel.
See also:
• "Understanding the Printer Menus" on page 314
• "Printer Setting Utility (Windows Only)" on page 59
• "SimpleMonitor (Windows Only)" on page 60
To Next Page
Loading...
Need help?
General