Using the Operator Panel Menus and Keypad 334
• Adjust Fusing Unit
Purpose:
To specify the optimum temperature settings for printing for the fusing unit. To lower the temperature,
set negative values. To increase, set positive values.
The default settings may not give the best output on all paper types. When the printed paper has
curled, try to lower the temperature. When the toner does not fuse on the paper properly, try to
increase the temperature.
NOTE:
• The print quality changes depending on the values you select for this item.
Values:
• Density Adjustment
Purpose:
To adjust the print density level within the range of -3 to +3. The factory default menu setting is 0.
• Clean Developer
Purpose:
To rotate the developer motor and stir the toner in the toner cartridge.
Values:
• Toner Refresh
Purpose:
To use up a toner cartridge when you need to replace it before the end of its life, or to stir the toner in
a new toner cartridge.
Values:
Plain 0*
-3 – +3
Light Card 0*
-3 – +3
Labels 0*
-3 – +3
Envelope 0*
-3 – +3
Recycled 0*
-3 – +3
Postcard 0*
-3 – +3
Yes Stirs the toner in a new toner cartridge.
No* Does not stir the toner in a new toner cartridge.
Black Yes Cleans the toner in the toner cartridge.
No* Does not clean the toner in the toner cartridge.
To Next Page
Loading...
Need help?
General