159 Printing Basics
5 Load print media on the paper cover with the top edge first and with the recommended print side
facing up.
6 Adjust the paper width guides until they rest lightly against the edges of the stack of print media.
7 Select the paper type from the print driver if the loaded print media is not plain paper. If a user-
specified print media is loaded in the PSI, you must specify the paper size setting by using the
print driver.
NOTE:
• For more information about setting the paper size and type on the print driver, refer to the Help provided for
the print driver.
Loading Envelope in the Priority Sheet Inserter (PSI)
NOTE:
• Be sure to fully insert the envelope until it stops. Otherwise, print media that is loaded on the MPF will be fed.
• When you print on envelopes, be sure to specify the envelope setting on the print driver. If not specified, the
print image will be rotated 180 degrees.
To Next Page
Loading...
Need help?
General