Xerox DocuPrint M205 fw

Using the Operator Panel Menus and Keypad 318
•Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the printer is turned off and then on.
Values:
NOTE:
• This item is displayed only when the printer is connected with a wired network.
• Status (DocuPrint M205 fw Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
Auto* Detects the Ethernet settings automatically.
10BASE-T Half Uses 10base-T half-duplex.
10BASE-T Full Uses 10base-T full-duplex.
100BASE-TX Half Uses 100base-TX half-duplex.
100BASE-TX Full Uses 100base-TX full-duplex.
Good Indicates good signal strength.
Acceptable Indicates marginal signal strength.
Low Indicates insufficient signal strength.
No Reception Indicates that no signal is received.