Name: Xerox PHASER 3635
Brand: Xerox
Rating: 4 (1 reviews)

To Next Page

To Previous Page

4-3

Phaser 3635MFP

REP 1.1

Repairs and Adjustments

Draft 4

REP 1.1 SMPS

Parts List on PL 1.12

Removal

WARNING

Switch off the electricity to the machine. Disconnect the power cord from the customer

supply while performing tasks that do not need electricity. Electricity can cause death or

injury. Moving parts can cause injury.

WARNING

Take care during this procedure. Sharp edges may be present that can cause injury.

CAUTION

Before performing this procedure, refer to General Disassembly Precautions, GP 10.

CAUTION

Ensure that E.S.D. procedures are observed during the removal and installation of the main

PWB. Make a visual check to ensure that the pins are fully inserted, without being damaged.

1. Remove the right side cover, REP 28.1.

2. Remove the duplex drive assembly, refer to REP 10.1.

3. Disconnect the inline connector in the harness from the SMPS fan.

4. Remove the SMPS cover, PL 1.12 Item 2.

5. Disconnect the following connectors from the SMPS:

•CON1

•CON2

•CON3

6. Remove the SMPS, Figure 1.

Figure 1 SMPS removal

Replacement

Replacement is the reverse of the removal procedure.

Remove 3 screws,

then the SMPS.

Other manuals for Xerox PHASER 3635

Questions and Answers:

Need help?

Do you have a question about the Xerox PHASER 3635 and is the answer not in the manual?

General