Xerox WorkCentre 3225

June 2014
6-13
Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
GP 1, GP 2
General Procedures and Information
GP 1 Diagnostics Entry and Exit
Purpose
This procedure describes the following items:
• How to enter Diagnostics
• The Diagnostic screen
• How to exit Diagnostics
Procedure
Use these steps to enter Diagnostics:
1. Make sure the machine is in Ready mode.
2. Press the <Menu> button.
3. Press the <#> button.
4. Enter 1934 on the keypad
5. Press the <OK> button.
6. From Diagnostics, use up and down arrows to scroll to the desired function.
To exit Diagnostics:
1. From the Diagnostics menu, use up and down arrows to scroll to <Exit Diagnostics>.
2. Press the <OK> button.
Refer to Section 6, Diagnostics for a listing of available functions within Diagnostic Mode.
GP 2 Machine Counters
Purpose
Use this procedure to access the Machine Counters.
NOTE: If frequent paper jams or printing pronblems are occurring, check the number of pages
the machine has printed or scanned. Replace worn parts if necessary.
Procedure
From the Control Panel:
1. Press the <Information> button
2. Use the up/down arrows to scroll to <Info Pages>, then press the <OK> button.
3. Scroll to <Usage Counter> then press the <OK> button to print a Usage Counter report.
or
1. Enter Diagnostics Mode, select <Diagnostics> then press the <OK> button
2. Use the up/down arrows to select <Report>, then press <OK>.
3. Use the up/down arrows to select <Usage Counter>, then press <OK>, then <OK> again
to print a Usage Counter report.