Xerox WorkCentre 3225

June 2014
6-23
Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
Entering Diagnostic Mode
General Procedures and Information
Machine Test EDC Mode DC330 Compo-
nent Control
106 Dev Bias K Dev Bias Status: [Off]
107 ATTR Bias K THV Bias Status: [Off]
K THV - Bias Status:[Off]
K THV Bias R Status: [0]
109 Fuser Heat Temp A Status: [0]
110 LSU LSU Mot1 Ready Status: [Low]
LSU Mot1 Run Status: [Off]
LD Power4 Status: [Off]
LSU HSync4 Status: [Low]
Table 2 Diagnostic Mode Menu - Machine Test
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Table 3 Diagnostic Mode Menu - Report
Level 1 Level 2 Level 3
Report Protocol Dump Yes
Supplies Info Yes
Configuration Yes
Error Info Yes
Usage Counter Yes
Component Check Yes
Fax Options Yes
Service Support Yes