Xerox WorkCentre Pro 423 - Mode Menu Items

WorkCentre Pro 423/428 2-88 CHAPTER 2 TROUBLESHOOTING
03/02 Level 2 Troubleshooting
SETUP Signal Contents(1/3) (Sample FIF below: 0801010504039090A2180183)
bit 8765 4321
Number of octets in information element “transmission capacity”
(transmission capacity-3 or later
Identifier of information element "transmission capacity": 04h
(fixed)
SETUP signal code 05h (fixed)
Transmision
capacity
-5
Transmision
capacity
-3
Transmision
capacity
-2
Transmision
capacity
-1
Message
type
Call No.
-2
Call No.
-1
Protocol
ID
SETUP
0000 0101
0000
Transmission capacity
length
0000 0011
F
0
F
(flag)
0--- ---
1--- ---
Call generation side
Call destination side
Identifier
0000 0100
Information
transmission
capacity
---0 0000
---0 1000
---1 0000
Voice
Unlimited digital
3.1KHz audio
101
Layer 1
protocol
---0 0010
---0 0011
-law (Japan and USA)
A-law
(Other than JP & USA)
* Analogue signal conversion.
Conversion for inter- communication is
from
-law into A-law. (By KDD in
Japan)
Info. Trans. capa.
1 0000
Call No. value
000 0001
Information
element
Description (Fixed unless described here)
Contents
08h (fixed)
Identifier
0000 1000
100
Information transfer by 64 kbps line switching
Transmision
capacity
-4
Layer 1
0 0010
Transfer mode
1001 0000
bits 4 to 1: Length (bytes) of Call number 2
Call No. Length
0001
Channel
-3
Channel
-1
Number of octets in information element
“channel” (channel-3 or
later)
Identifier of information element "channel": 18h (fixed)
Channel
-2
1000
E: Channel
change
---- 0---
---- 1---
Specified channel
changeable
E
0
Ch:
Channel
selection
---- -000
---- -001
---- -010
---- -011
No channel
B1 channel
B2 channel
Arbitrary channel
Ch
011
Call status length
0000 0001
Identifier
0001 1000
Information elements may be further added.
If FIF is longer than this, see the information elements on the next page and
later (SETUP-2/3 and 3/3).