Xerox WorkCentre Pro 423 - Additional Tray Kit; Product Code; Installation Procedure

WorkCentre Pro 423/428 8-2 CHAPTER 8 ACCESSORIES
03/02 8.1 Additional Tray Kit
8.1 Additional Tray Kit
8.1.1
Product Code
Additional Tray Kit: EL200122 (FX)
: EL200150 (FXA,FXK,TFX,PRC)
: EL200190 (DMO-E)
8.1.2 Installation Procedure
1. Check the accessories. (Figure-1)
1) Tray Unit…………..1
(Figure-1) j0hn8001
2. Turn the main unit power off.
On printer or Fax-equipped machines, ensure that outstanding jobs have cleared
before servicing or interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the “Job in Memory” indicator on the control
panel goes out. Press “Job Status:Stop” button and confirm that the job has cleared
from the “Current Jobs” folder.
• Printer machines: Ensure that “Ready to print or fax” is indicated on the printer
control panel.
WARNING
Switch off the machine and disconnect the power cord.
3. Remove the Tray 3.
4. Remove the Front Blind Cover. (Figure-2)
1) Release the Hook.
2) Remove the Front Blind Cover.
(Figure-2) j0hn8002
5. Return Tray 3 to the original position.
6. Install the Tray Unit (Tray 4).
7. Load paper on Tray 4.
8. When installing the Tray 4, press the Tray Front/Rear Latch to the rear to hook, and
then install the Tray 4.
(Figure-3) j0hn8105
9. Affix the Size Label to Tray 4 according to the paper size.
10. Connect the power cord and turn on the power.
11. Check whether Tray 4 use is set.
1) Enter C/E Mode.