Xerox WorkCentre Pro 423 - Offset Output Kit; Product Outline

WorkCentre Pro 423/428 8-8 CHAPTER 8 ACCESSORIES
03/02 8.4 Offset Output Kit
8.4 Offset Output Kit
8.4.1
Product Outline
This kit enables copy offset output to the Top Tray.
8.4.2 Product Code
Offset Output Kit: EL200126
8.4.3 Installation Procedure
1. Check the accessories. (Figure-1)
1) OCT Assembly…………… 1
2) Paper Weight…………….. 1
3) Holder……………………... 1
4) Screw……………………… 1
5) Tapping Screw…………… 4
(Figure-1) j0hn8010
2. Turn the main unit power off.
On printer or Fax-equipped machines, ensure that outstanding jobs have cleared
before servicing or interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the “Job in Memory” indicator on the control
panel goes out. Press “Job Status:Stop” button and confirm that the job has cleared
from the “Current Jobs” folder.
• Printer machines: Ensure that “Ready to print or fax” is indicated on the printer
control panel.
WARNING
Switch off the machine and disconnect the power cord.
3. Pull out the R/H Unit.
4. Remove the R/H Lower Cover. (Figure-2)
1) Remove the screws (2).
2) Remove the Handle.
3) Remove the screws (2).
4) Remove the R/H Lower Cover.
(Figure-2) j0hn8011
5. Remove the Exit Assembly. (Figure-3)
1) Remove the screw.
2) Push in the Rear Upper Rail.
3) Loosen the Screws (2).
4) Remove the Screws (2).
5) Remove the Exit Assembly.