03/02 8.3 Electronic Sort Kit
WorkCentre Pro 423/428 8-7 CHAPTER 8 ACCESSORIES
(Figure-3) j0hn8008
6. Connect the Wire Harness and Flat Cable. (Figure-4)
1) Connect the Wire Harness.
2) Attach the Cores (2) to the Flat Cable.
3) Connect the Flat Cable.
(Figure-4) j0hn8009
7. Return the Electrical Cover and Rear Cover to their original positions.
8. Connect the power cord and turn on the power.
9. Check whether the Hard Disk is connected.
1) Enter C/E Mode.
2) Set the Chain/Function code “50/52" and press the Start button.
3) Check that the set value is 1.
4) Exit C/E Mode.
To Next Page
Loading...
