03/02 8.8 Stapler Finisher
WorkCentre Pro 423/428 8-17 CHAPTER 8 ACCESSORIES
8.8 Stapler Finisher
8.8.1
Product Outline
Copies are delivered facing up and they will be stapled.
- This kit is installed on machines with an OCT.
- If an OCT is not already installed, the following kit is necessary. Obtain the kit and install
it before installing the finisher.
Offset Output Kit (Product Code: EL200126)(8.4)
8.8.2 Product Code
Staple Finisher: QL200057 (FX)
: QL200134 (FXA, FXK, TFX, PRC, DMO-E)
: QL200203 (DMO-W)
8.8.3 Installation Procedure
1. Check the accessories. (Figure-1)
1) Link Guide………………. 1
2) Rail Cover………………. 1
3) Rear Stay Cover……….. 1
4) Clip……………………… 2
5) Screw(Large)…………... 2
6) Base Frame……………. 1
7) Finisher……………….… 1
8) Screw(Small)…………... 1
9) Side Tray……………….. 1
10) Finisher Receiving Tray.. 1
11) User Guide………….… 1
(Figure-1) j0hn8066
To Next Page
Loading...
