WorkCentre Pro 423/428 8-18 CHAPTER 8 ACCESSORIES
03/02 8.8 Stapler Finisher
2. Turn the main unit power off.
On printer or Fax-equipped machines, ensure that outstanding jobs have cleared
before servicing or interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the “Job in Memory” indicator on the control
panel goes out. Press “Job Status:Stop” button and confirm that the job has cleared
from the “Current Jobs” folder.
• Printer machines: Ensure that “Ready to print or fax” is indicated on the printer
control panel.
WARNING
Switch off the machine and disconnect the power cord.
3. Remove the Blind Cover from the right side of the printer (Figure-2).
1) Remove the screws (2).
2) Remove the Blind Cover.
(Figure-2) j0hn8023
4. Remove the Finisher Blind Covers (4). (Figure-3)
1) Remove the Finisher Blind Covers (4) with a flat mini driver or similar tool.
(Figure-3) j0hn8142
5. Install the Link Guide. (Figure-4)
1) Install the Link Guide and secure it with the Screws (2).
(Figure-4) j0hn8067
To Next Page
Loading...
