Xerox WorkCentre Pro 423 - Page 197

03/02 How to use the Diagnostic C/E Mode
WorkCentre Pro 423/428 2-165 CHAPTER 2 TROUBLESHOOTING
Chain Function Item
Min.
value
Default
Max.
value
Amount of
Change
Adjustment Remarks
Communication 11: Polling Reservation 12: Polling
13: Monitor report 14: Document passage stamp 15:
duplex document 16: (None) 17: (None)
28 145 Function registered at lower right of customized fax screen 0 0D 17 1
0: No setting 1: Transmission screen 2: Document
type 3: Transmission darkness 4: Communication
mode 5: Read specification 6: Synthesized
transmission 7: Transmission sheet 8: Transmitter
record 9: Time Specification 10: Confidential
Communication 11: Polling Reservation 12: Polling
13: Monitor report 14: Document passage stamp 15:
duplex document 16: (None) 17: (None)
28 150 Transmitting Screen Display 0 00 1 1 0: Do not display 1: Display
28 151 Telephone Directory Display Start Number 1 0001 200 2 1 to 200 (500 at memory extension)
28 152
Unit of charge (yen) used to calculate the number of units for
division management when a charge notice is received from
ISDN
0X000
0
0A00 0XFF09 2 0X0000 to 0XFF09: 0.0 to 255.9(yen)
28 153 Accumulation by 90-degree rotation at fax transmission or
polling reserved accumulation
0 01 1 1 0: No accumulation by rotation 1: Accumulation by
rotation
28 154 A4SEF reduced accumulation or equal-size accumulation if
accumulation by auto resizing is specified to LETTER-SEF
document
0 00 1 1 0: Equal-size accumulation 1: A4SEF reduced
accumulation
28 155 Print Priority Setting
Three priority levels each for received print, automatic
report, and local print (System data: OR of priority levels)
0 00 63 1 0 to 63(0 to 0X3F)
bit0,1: received print priority(0 to 2) (0:L, 2:H) Default=0
bit2,3: auto report priority(0 to 2) (0:L,2:H)
Default=0
Bit4,5: local print priority(0 to 2) (0:L,2:H) Default=0
28 160 Initial Scanner Screen Type
A specified screen appears if the scanner screen is in initial
mode at M/C boot-up or auto clearance or All Clear is
pressed in scanner mode.
0 00 3 1 0: Basic scanner 1: Customized scanner 2: Scanner
function list 3: No scanner screen
28 161 Function registered at upper left of customized scanner
screen
0 01 7 1 0: No setting 1: Read resolution 2: Document type 3:
Read darkness 4: Read size 5: Read resizing factor
6: Duplex document 7: Mixed-size document
28 162 Function registered at upper middle of customized scanner
screen
0 02 8 1 0: No setting 1: Read resolution 2: Document type 3:
Read darkness 4: Read size 5: Read resizing factor
6: Duplex document 7: Mixed-size document