03/02 How to use the Diagnostic C/E Mode
WorkCentre Pro 423/428 2-197 CHAPTER 2 TROUBLESHOOTING
Chain Function Item Content Default Description
Access
by
57 830 G4 Trace Mode 0:Overwrite 1:Buffer full
2:Mixed
00 Specifies the method of receiving/storing the protocol tracing obtained into
memory in the G4 communication. “Overwrite” is a FIFO method for the
signal, “Buffer Full” is to fill the memory with signal, and “Mixed” is the
combination of data received immediately before and after the trace.
CE
57 831 G4 Trace Layer 2:Data link 3:Network
4:Transport 5:Session
6:Presentation 8:Between CPUs
05 In the G4 communication, this data specifies the protocol tracing layer for
obtaining. It is necessary to specify the layer before activating communication
for obtaining the protocol.
CE
57 832 G4 Trace Channel 0:All channels 1:Specific channel 01 In the G4 communication, this data specifies the channel for the protocol
tracing for obtaining. When “All channels” is selected, it is necessary to
understand the usage before changing data as the trace storage capacity for a
channel will be reduced.
CE
To Next Page
Loading...
