03/02 How to use the Diagnostic C/E Mode
WorkCentre Pro 423/428 2-199 CHAPTER 2 TROUBLESHOOTING
Chain Function Item Description Default Description Access by
58 102 Page split margin on outputting prints 0mm to 127mm (1step=1mm) 16 When the data overflew out of the standard size by specifying the page
margin for receive operation, a process in Chain=058 and Function=101
(100% or auto reduced for the data received) will be enabled. This data
specifies the page margin amount.
User
58 103 Page combined on printing data received 0:No combined 1:Combined 00 In the identical jobs of receive operation, this data determines whether or
not to enable the feature that two pages of same standard size data will
be reduced for output in a page of print (2in1).
User
58 104 Printing A3-wide received document in the
same or reduced size on Ledger paper
0: Print an A3-wide received
document in the same size(100%)
on Ledger paper by deleting both
ends from the image information
1: Print an A3-wide received
document on Ledger paper by
reducing into 93.9% (279/297).
00
58 105 Selecting an tray for outputing received
document, report, and confirmation prints
0:Face down tray output 1:Face up
tray output
00 Specifies outputting documents/report and copies separately in the Side
Tray Kit (Face Up Tray) installed machines.
User
58 150 Fast scan line resolution (inch) 0:Disable reception 1: Enable
reception bit2:200ppi bit4:300ppi
bit5:400ppi bit6:600ppi
116(007
4)
Specifies the fast scan line resolution by the inch. Do not change the
data unless otherwise instructed.
CE
58 151 Fast scan line resolution (mm) 0:Disable reception 1: Enable
reception bit2:8dot/mm
bit4:12dot/mm bit5:16dot/mm
52(0034
)
Specifies the fast scan line resolution by the mm. Do not change the
data unless otherwise instructed.
CE
58 152 Slow scan line resolution (inch) 0:Disable reception 1: Enable
reception bit1:100ppi bit2:200ppi
bit4:300ppi bit5:400ppi bit6:600ppi
118(007
6)
Specifies the slow scan line resolution by the inch. Do not change the
data unless otherwise instructed.
CE
58 153 Slow scan line resolution (mm) 0:Disable reception 1: Enable
reception bit1:3.85line/mm
bit2:7.7line bit4:11.55line/mm
bit5:15.4line/mm
54(0036
)
Specifies the slow scan line resolution by the mm. Do not change the
data unless otherwise instructed.
CE
58 160 Memory threshold to reject documents
received
0 to 100% (1step=1%) 100%=All is
rejected
00 Specifies the remaining memory capacity that is capable of handling
image data rreceived. The customers who want to use this machine
only for sending operation, should set the data to 100%.
CE
58 161 Memory threshold to shift to real time
receive
0 to 99% (1step=1%) 20 When the remaining memory capacity available for processing the
communication image data becomes low, Main unit moves to the
realtime receive operation that receives data continuously while printing
the data received. This data specifies the threshold of remaining memory
capacity available to move to the real time receive mode. As the setup
value is greater, it is easier to move to the real time receive mode.
However, the IOT will be used more frequently and it will be harder to
use the dual access feature that uses IOT.
CE
To Next Page
Loading...
