03/02 8.2 Upgrade Kit A(4MB) FX Only
WorkCentre Pro 423/428 8-5 CHAPTER 8 ACCESSORIES
(Figure-3) j0hn8005
5. Return the Electrical Cover and Rear Cover to their original positions.
6. Connect the power cord and turn on the power.
7. Check whether the 90-degree rotation function is installed.
1) Enter C/E Mode.
2) Set the Chain/Function code “50/9” and press the Start button.
3) Change the set value to 1.
8. Check whether Page Memory is connected.
1) Set the Chain/Function code “50/40” and press the Start button.
- If one Page Memory PWB is added, check that the set value is 1.
- If two Page Memory PWBs are added, check that the set value is 2.
- Check that the set value is 2.
To Next Page
Loading...
