Xerox WorkCentre Pro 423 - Page 534

03/02 8.22 Stamp Kit (Red)
WorkCentre Pro 423/428 8-57 CHAPTER 8 ACCESSORIES
4. Remove the Stamp Cover. (Figure-3)
1) Remove the screw.
2) Remove the Stamp Cover.
(Figure-3) j0hn8064
5. Install the Stamp Solenoid. (Figure-4)
1) Install the Stamp Solenoid.
2) Connect the Connector.
(Figure-4) j0hn8065
6. Reinstall the Stamp Cover removed in Step 4.
7. Put a stamp into the Stamp Solenoid.
8. Close the DADF Top Cover and Chute.
9. Connect the power cord and turn on the power.
10. Check the stamp operation and position.
- If necessary, adjust the stamp position.
1) Enter C/E Mode.
3) Change the set value of Chain/Function code "21/86."
Min Nominal MAX
Setting
range
0
-5mm
15
10mm
30
25mm
Change rate 1mm/1Step 1mm/1Step 1mm/1Step
11. Store the accessory stamp replacement kit (consumable).