Xinje VH6 Series - Page 70

64
Group P7: Fault parameters
Parameter
Name
Setting range
Default
value
Modify
Modbus
address
11: Input phase loss
12: Output phase loss
13: Radiator overheating
14: Contactor fault
15: Current detection fault
16: Motor tuning fault
17: Code disk failure
18: Short circuit fault of motor to
ground
19: Load drop
20: Wave by wave current limiting
fault
21: Pole position detection failed
22: UVW signal feedback error
23: Brake resistance short circuit
24: Brake pipe overload
25: Brake pipe straight through
26: SVC stall fault
43: External fault
44: Communication failure
45: EEPROM read / write failure
46: Operation time arrival
47: Power on time arrival
48: User defined fault 1
49: User defined fault 2
50: PID feedback loss during
operation
51: Running switch motor
52: Speed feedback deviation too
large
53: Motor over speed
54: Motor over temperature fault
55: Point to point slave failure
P7-01
Second time fault type
-
-
-
P7-02
First time fault type
-
-
-
P7-03
Third time (last time) fault frequency
-
-
-
-
P7-04
Third time (last time) fault current
-
-
-
-
P7-05
Third time (last time) fault bus voltage
-
-
-
-
P7-06
Third time (last time) fault input
terminal status
-
-
-
-
P7-07
Third time (last time) fault output
terminal status
-
-
-
-
P7-08
Third time (last time) fault VFD status
-
-
-
-
P7-09
Third time (last time) fault power on
time
Unit:minute
-
-
-
P7-10
Third time (last time) fault operation
time
Unit:minute
-
-
-
P7-11
Location information of the third
-