Yamaha F90D - Removing the Power Trim and Tilt Unit

6D81G11
7-24
1
2
3
4
5
6
7
8
9
Removing the power trim and tilt unit
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever
1
.
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power trim and tilt unit
should lose fluid pressure.
NOTE:
• If the power trim and tilt does not operate,
loosen the manual valve and tilt the out-
board motor up manually.
• If the manual valve is loosened, be sure to
tighten it to the specified torque after tilting
the outboard motor up.
2. Remove the holders
2
and plastic ties,
and then pull out the PTT motor leads
3
.
3. Remove the bolt
4
and disconnect the
ground lead
5
.
4. Remove the circlips
6
, then the lower
mounting shaft
7
.
5. Remove the circlip
8
, then the upper
mounting shaft
9
.
NOTE:
Hold the power trim and tilt unit with one
hand, and pull the upper mount shaft out at a
downward angle with the other.
6. Remove the power trim and tilt unit
0
.
T
R
.
.
Manual valve:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
S6D83150
1
S60C7745
S6D87280
2
3
6
7
8
9
0
5
4
6
Power trim and tilt unit