Yamaha F90D - Page 192

6D81G11
7-42
1
2
3
4
5
6
7
8
9
5. Install a new O-ring, the joint, and the
power trim and tilt motor
5
by installing
the bolts, then tightening them to the
specified torque.
6. Add fluid of the recommended type to the
first level at the bottom of the trim cylin-
der.
7. Install the balls
6
into the tilt cylinder,
and then insert the tilt cylinder into the
trim cylinder
7
.
NOTE:
Apply grease to the balls from falling out of
the cylinder installation.
8. Install the trim cylinder end screw
8
, and
then tighten it to the specified torque.
9. Fully extend the tilt rod, and then add suf-
ficient fluid of the recommended type to
the correct level.
10. Install the reservoir cap
9
.
Recommended power trim and tilt
fluid:
ATF Dexron
II
T
R
.
.
PTT motor bolt:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
S6D87450
S6D87460
5
Trim cylinder wrench:
YB-06175-2B
T
R
.
.
Trim cylinder end screw
8
:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
S6D87480
8
Tilt cylinder and trim cylinder