Yamaha FJR1300N 2001 User Manual

3 - 52
CHK
ADJ
CHANGING THE COOLANT
EAS00105
CHANGING THE COOLANT
1. Stand the motorcycle on a level surface.
NOTE:
• Place the motorcycle on a suitable stand.
• Make sure the motorcycle is upright.
2. Remove:
• side cowlings
• front cowling assembly
Refer to “COWLINGS AND COVERS”.
3. Disconnect:
• coolant reservoir hose
1
4. Drain:
• coolant
(from the coolant reservoir)
5. Remove:
• radiator cap
1
WARNING
@
A hot radiator is under pressure. Therefore,
do not remove the radiator cap when the
engine is hot. Scalding hot fluid and steam
may be blown out, which could cause seri-
ous injury. When the engine has cooled,
open the radiator cap as follows:
Place a thick rag or a towel over the radia-
tor cap and slowly turn the radiator cap
counterclockwise toward the detent to
allow any residual pressure to escape.
When the hissing sound has stopped,
press down on the radiator cap and turn it
counterclockwise to remove.
The following procedure applies to all of the
coolant drain bolts and copper washers.
6. Remove:
• coolant drain bolt
1
(along with the copper washer)
7. Drain:
• coolant
(from the engine and radiator)

Yamaha FJR1300N 2001 Specifications

General

Displacement	1298 cc
Compression Ratio	10.8:1
Fuel System	Fuel injection
Final Drive	Shaft
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Engine Type	Liquid-cooled, 4-stroke, DOHC, inline 4-cylinder
Bore x Stroke	79.0 mm x 66.2 mm
Ignition	TCI
Transmission	5-speed
Front Suspension	Telescopic forks
Rear Suspension	Swingarm
Front Brakes	Dual disc
Rear Brakes	282mm disc, single-piston caliper
Wheelbase	805 mm
Seat Height	805 mm
Fuel Capacity	25 liters
Dry Weight	264 kg / 582 lbs