Yamaha FT60D - Page 46

SPEC
Specifications
2-23
6C13G11
Bracket unit
Retaining plate bolt M6 10 1.0 7.4
Tiller handle nut — 37 3.7 27.3
Self-locking nut — 40.43.0
Engine stop lanyard switch nut — 20.21.5
Tiller handle bracket nut — 37 3.7 27.3
Tiller handle bracket bolt M12 37 3.7 27.3
Engine start switch nut — 40.43.0
Shift rod detent bolt — 18 1.8 13.3
PTT switch bracket bolt M6 10 1.0 7.4
Flushing hose adapter screw M6 2 0.2 1.5
Engine oil drain bolt M14 17 1.7 12.5
Muffler bolt M6 10 1.0 7.4
Exhaust manifold bolt M6 10 1.0 7.4
Oil pan bolt M8 27 2.7 20.0
Oil strainer bolt M6 10 1.0 7.4
Upper mounting nut M8 24 2.4 17.7
Self-locking nut — 22 2.2 16.2
Grease nipple — 30.32.2
Power trim and tilt unit
PTT motor bolt M5 4 0.4 3.0
Reservoir cap — 70.75.2
Manual valve — 20.21.5
Gear pump bolt M5 5 0.5 3.7
Lever bolt M3 3 0.3 2.2
Relief valve seat cap bolt
M4 4 0.4 3.0
M5 5 0.5 3.7
Gear pump housing bolt M5 5 0.5 3.7
Gear pump bracket bolt
M3 3 0.3 2.2
M5 4 0.4 3.0
Tilt cylinder end screw — 110 11.0 81.1
Trim cylinder end screw — 80 8.0 59.0
Tilt piston bolt M12 61 6.1 45.0
Part to be tightened Thread size
Tightening torques
N·mkgf·mft·lb