Yamaha RCX142 User Manual

4-63
4
Operation
10. “PROGRAM” mode
10.3.7 Changing the program attribute
Editing and erasing the programs can be prohibited by specifying the program attribute.
There are two program attributes: RW and RO. Each time a change is made a program
attribute is alternately switched.
1. RW (read or write)
Program contents can be edited and erased.
This is automatically specified as a default when a program name is registered.
2. RO (read only)
Program contents cannot be edited or erased.
[Procedure]
1) In “PROGRAM>DIR” mode, use the cursor (↑/↓) keys to select the program with the
attribute to be changed.
2) Press the
F 10
(ATTRBT) key to enter “PROGRAM>DIR>ATTRBT” mode.
A confirmation message appears on the guideline.
Fig. 4-10-25 Changing a program attribute
PROGRA
>DIR>ATTRBT <TEST2 >
No. RW/RO
1 *TEST2 50 907 RW
2 PARTS100 38 843 RW
3 TEST100 100 1968 RW
4 TEST200 80 1525 RW
Change attribute OK?
YES NO
Name Line Byte
3) Press the
F 4
(YES) key to change the program attribute.
Press the
F 5
(NO) key if you want to cancel the change.
10.3.8 Displaying object program information
To display information on an executable object program, proceed as follows.
[Procedure]
1) Press the
F 11
(OBJECT) key to enter “PROGRAM>DIR>OBJECT” mode.
2) Object information appears as shown below.
Fig. 4-10-26 Object program information
PROGRAM >DIR>OBJECT
<TEST2 >
No. RW/RO
1 TEST2 55 750 RO
2 COMMON 20 374 RO
3 SEQUENCE 40 320 RO
Name Line Byte

Yamaha RCX142 Specifications

General

Brand	Yamaha
Model	RCX142
Category	Controller
Language	English