3.2 Operating Procedures for Utility Functions
3.2.20 Initialize Vibration Detection Level (Fn01B)
3-50
Operating Procedure
Step Operation Result
1
Press the Key to display the
Utility Mode Main Menu, and then
use the Key or Key to
select Fn01B.
2
Press the Key.
The Fn01B (Initialize Vibration
Detection Level) execution display
will appear.
3
Press the Key.
Init will flash on the display and the
vibration level will be updated.
Note: The vibration detection level will be
continuously updated until you
press the Key again.
4
Press the Key.
The vibration detection level will be
initialized.
When processing has been com-
pleted, the status display will flash
DONE for approximately one sec-
ond and then return to 1:RUN.
Also, Pn312 (Vibration Detection
Level) will be updated.
Continued on next page.
1:RUN
FUNCTION
Fn014:Opt Init
Fn01B:Viblvl Init
Fn01E:S vMotOp ID
Fn01F:FBOpMot ID
Level Init
1:RUN
Vibration Detect
S tart : [DATA]
Return: [S ET]
Level Init
1:RUN
Vibration Detect
Init
Level Init
1:RUN
Vibration Detect
Done
To Next Page
Loading...
