EasyManua.ls Logo

YASKAWA E-7 Series - JOG Speed Table Initialization (Fnb08)

YASKAWA E-7 Series
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.2 Operating Procedures for Utility Functions
3.2.39 JOG Speed Table Initialization (FnB08)
3-123
3
Utility Functions
* If the key is pressed in an operation prohibited state, “Error.” is displayed for
approximately 2 seconds and then the display returns to the FnB07 operation screen.
In this case, make the setting again by referring to Preparation on page 3-122.
3.2.39
JOG Speed Table Initialization (FnB08)
This function initializes JOG speed tables and restores the default set-
tings.
Preparation
Always check the following before you initialize a JOG speed table.
The parameters must not be write-prohibited (Fn010 must be set to
0000).
A JOG speed table save operation must not be in progress for any
means other than the digital operator.
Execution of the RES command must not be in progress.
Operating Procedure
4
When ZONE table initialization has
been completed normally, “Done.”
is displayed.
5
Press the key to return to the
Utility Function Mode main menu.
Continued from previous page.
Step Operation Result
㹀㹀ࠉࠉࠉࠉࠉ㹘㹭㹬㹣㹇㹬㹧㹲
㹂㹭㹬㹣㸬
㹎㹰㹣㹱㹱ࠉ㹙㹑㹃㹒㹛ࠉ㹩㹣㹷㸬
㹀㹀ࠉࠉࠉࠉࠉ㹄㹓㹌㹁㹒㹇㹍㹌
㹄㹬㹀㸮㸴ࠉ㹎㹅㹋ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸵ࠉ㹘㹍㹌㹃ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸶ࠉ㹈㹑㹎㹂ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸷ࠉ㹘㹑㹃㹒
Step Operation Result
1
Press the key to open the Util-
ity Function Mode main menu, and
move the cursor with the
keys to select FnB08.
Continued on next page.
㹀㹀ࠉࠉࠉࠉࠉ㹄㹓㹌㹁㹒㹇㹍㹌
㹄㹬㹀㸮㸵ࠉ㹘㹍㹌㹃ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸶ࠉ㹈㹑㹎㹂ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸷ࠉ㹘㹑㹃㹒
㹄㹬㹀㸮㸿ࠉ㹋㹭㹬㹧㹲㹭㹰

Table of Contents

Related product manuals